NulinkFuncSwitch
If you want to use NuLink with CoIDE, CoMDKPlugin, CoIARPlugin and other embedded development tools, such as MDK and IAR, you can use the NulinkFuncSwitch tool.
|
NuLinkFunctionSwitch is a tool designed for Nuvoton Nulink to switch between the original Nulink and CoLinkEx.
NulinkFuncSwitch Functions:
- 1. Work AS CoLinkEx:
Click this button you can change the original Nulink to "CoLinkEx", so the Nulink can be used in CooCox CoIDE and other CooCox software.
- 2. Work AS Nulink:
Click this button you can change the "CoLinkEx" to Nulink, so the Nulink can be used in Keil Realview MDK and IAR Embedded Workbench.
|
 |
Warnings:
- Only the Nuvoton Nulink can use this software, the CoLinkEx which use LPC1343 could not use this tool.
- When the switching is executing, you are not allowed to power down the Nulink (or CoLinkEx) or use the link to download or debug program. If you did above, the switching will be stopped, and you need to rewrite the link with NuMicro ICP programming Tool and a Nulink.
- If you are using Nu_Link-Me_001V1.1, and the Nulink have been switched to CoLinkEx with the firmware we provided on the internet, you can't use this tool because the old version of CoLinkEx
firmware is not compatible. You need to switch "CoLinkEx" to Nulink, update the Nulink to new version
with ISP tool by Nuvoton, and then you can use NuLinkFunctionSwitch to switch the Nulink between the
original Nulink and CoLinkEx.
- If you have not installed CoLinkEx driver on your PC, you can only use this tool to switch Nulink
to CoLinkEx. CoLinkEx driver can be downloaded from http://www.coocox.org/Colinkex.htm.
Download:
After installing NulinkFuncSwitch, you could use it in CoIDE, MDK or IAR freely. (Before using Nulink, don't forget to install NuLink's USB driver.)
Other information:
|
|
